Red Hat Server tc3100 Guía de usuario descargar pdf (Pagina 133)

Removal and Replacement 133

Removal and Replacement

Deskside Base/External Covers (HP-Qualified Only)

The deskside base and external covers must be removed from the chassis before

the top cover, the midplane, the light pipes, or the power switch extender arm can

be replaced.

Follow the procedures below to remove and replace the deskside conversion kit:

Powering Down the Disk System

1 Complete the appropriate system administration tasks for taking this storage

device offline for your operating system.

2 Power down the disk system.

3 Disconnect the power cord(s) and SCSI cable(s).

4 Remove the power supplies and place them on an anti-static surface.

5 Remove the disk modules and carefully place them on an anti-static surface.

Be sure to note the slots from which the disk modules were removed to

replace them in the same slots.

Removing the deskside base and external covers from the disk system

Tools

■ Torx T25 driver

■ ESD strap

Procedure

1 Rotate the disk system and place it on its end with the end cap facing up.

2 Remove the two M5 end cap retaining screws from the bottom of the disk

system using a Torx T25 driver. See Figure 61.

3 Rotate the end cap off the bottom of the disk system.

4 Pull the end cap away from the disk system.

1 2 ... 128 129 130 131 132 133 134 135 136 137 138 ... 157 158

Sin comentarios

Red Hat Server tc3100 Guía de usuario Pagina 133