Red Hat NETSCAPE MANAGEMENT SYSTEM 6.01 - CUSTOMIZATION Manual de servicio descargar pdf (Pagina 21)

LEGATO NetWorker, Release 6.0.1-x, HP OpenVMS Version

Release Supplement

Chapter 1: NetWorker Software Release 6.0.1-D

EXPIRATION DATE/TIME: Fri Oct 29 10:14:34 2004

VOLUME LABEL: wumpus.tz87.008

SHARING MODE: single user

ORDERING MODE: sequential access

RMU/RECOVER/LIBRARY Fails When Specified Save Set Does Not Exist (Oracle

Rdb Module)

RMU generates a bugcheck if you specify a save set name that does not exist.

Problem With Rdb V7.2 Using A Plan (Oracle Rdb Module)

There is a problem with Rdb V7.2 when using a plan file. You will get an ACCVIO

when you try to use a plan file. The following shows an example of the ACCVIO:

$ RMU/BACKUP/PLAN backup.plan

%SYSTEM-F-ACCVIO, access violation, reason mask=04, virtual

address=000000007FFA4F38, PC=0000000000706014, PS=00000000

%RMU-F-FATALOSI, Fatal error from the Operating System

Interface.

%RMU-I-BUGCHKDMP, generating bugcheck dump file

SYS$SYSDEVICE:[ORACLE_RDB]RMUBUGCHK.DMP;

%RMU-F-FTL_BCK, Fatal error for BACKUP operation at 23-FEB-2006

17:23:59.68

Save Fails With RPC Error When Using TCPware

The TCPware TCP/IP software for OpenVMS supports a maximum write size of 65440

bytes, which is lower than the default write size of the NetWorker save program.

Therefore, if you are using TCPware TCP/IP software and attempting to save large

files that exceed TCPware’s maximum write size limitation, the save program may fail

with the following error:

RPC error -- unable to send

If this problem occurs, define the logical name NSR$MAX_WRITESZ in NetWorker’s

startup command procedure (SYS$STARTUP:NSR$STARTUP.COM) to a value that is

equal to or less than the TCPware size limit. The recommended value for the

NSR$MAX_WRITESZ logical is 65024 bytes. (Note that the value assigned to this

logical name should be a multiple of 512 bytes.)

The NetWorker startup command procedure already contains the following,

commented-out definition:

$! define/system/executive nsr$max_writesz 65024

To define the NSR$MAX_WRITESZ logical name, simply remove the comment

character (the exclamation point (!)) from this definition and re-execute the

SYS$STARTUP:NSR$STARTUP.COM command procedure.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 27 28

Sin comentarios

Red Hat NETSCAPE MANAGEMENT SYSTEM 6.01 - CUSTOMIZATION Manual de servicio Pagina 21