Red Hat LINUX VIRTUAL SERVER 4.5 - ADMINISTRATION Guía de instalación Pagina 132

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 148
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 131
www.vmware.com
132
Guest Operating System Installation Guide
At a command prompt on a Windows host, type
ipconfig /all
At a command prompt on a Linux host, type
ifconfig
Note the hosts IP address for VMnet8 and change the last octet so it is greater
than the last octet in the IP address of the host.
For example, if the host IP address is 192.168.160.1, then the virtual machine’s
IP address is 192.168.160.###, where ### is any number greater than 2 and less
than 128.
For the subnet mask, enter 255.255.255.0.
For the router gateway, enter the NAT services IP address (192.168.160.2 in this
example).
Note that with Network Address Translation, there are two IP addresses in use
on the host:
The IP address assigned to the interface for VMnet8 shows up in the
ipconfig output with a 1 in the last octet.
The IP address used by the NAT device itself always uses 2 as the last octet.
6. Finish the installation by following the on-screen instructions.
After you finish the installation, install VMware Tools, which installs and loads the
CPU idler program.
VMware Tools for NetWare 5.1 Guest Operating Systems
Be sure to install VMware Tools in your guest operating system. For details, see the
manual for your VMware product or follow the appropriate link in the knowledge base
article at www.vmware.com/support/kb/enduser/std_adp.php?p_faqid=340.
Installing VMware Tools also installs and loads the CPU idler program. NetWare servers
do not idle the CPU when the operating system is idle. As a result, a virtual machine
takes CPU time from the host regardless of whether the NetWare server software is
idle or busy. To prevent unnecessary slowdowns, VMware recommends that, after you
install VMware Tools, you keep the NetWare CPU idle program loaded.
Known Issues
Updated LSI Logic SCSI Driver
VMware GSX Server and VMware ESX Server: If you are running NetWare 5.1
Support Pack 6, you should install the latest LSI Logic SCSI driver, which has many bug
Vista de pagina 131
1 2 ... 127 128 129 130 131 132 133 134 135 136 137 ... 147 148

Comentarios a estos manuales

Sin comentarios