Red Hat DIRECTORY SERVER 7.1 - GATEWAY CUSTOMIZATION Guía de instalación descargar pdf (Pagina 94)

packages must already be installed, and the Administration Server must already

be configured and running.

1. Make the setup .inf file. It must specify the following directives:

[General]

FullMachineName= dir.example.com

SuiteSpotUserID= nobody

SuiteSpotGroup= nobody

[slapd]

ServerPort= 389

ServerIdentifier= dir

Suffix= dc=example,dc=com

RootDN= cn=Directory Manager

RootDNPwd= password123

NOTE

There are two sections of directives in the instance creation: [General] and

[slapd]. Installing the Administration Server, which is done in a default setup

file, requires a third parameter as well, [admin], for the Administration Server.

This parameters correspond to the information supplied during a typical setup. The .inf file

directives are described more in Section 3.5.1, “.inf File Directives”.

2. Run the setup-ds-admin.pl script with the -s and -f options.

/usr/sbin/setup-ds-admin.pl -s -f /export/ds-inf/setup-single.inf

Running setup-ds-admin.pl installs only a Directory Server instance, so the setup file must

specify parameters only for the Directory Server. -s runs the script in silent mode, and -f

/export/ds-inf/setup.inf specifies the setup file to use.

After the script runs, the new Directory Server instance is configured and running, as with a

standard setup.

3.3. Sending Parameters in the Command Line

Chapter 6. Advanced Setup and Configuration

1 2 ... 89 90 91 92 93 94 95 96 97 98 99 ... 153 154

Sin comentarios

Red Hat DIRECTORY SERVER 7.1 - GATEWAY CUSTOMIZATION Guía de instalación Pagina 94