Red Hat DEVICE-MAPPER MULTIPATH 5.2 Manual de usuario descargar pdf (Pagina 10)

The "product" value varies depending on the ETERNUS DX that is to be connected.

Refer to the following table for the appropriate value.

ETERNUS DX to be used "product" value

DX60 S3/DX100 S3/DX200 S3,

DX200F,

DX60/DX60 S2, DX80/DX80 S2, DX90/DX90 S2

ETERNUS_DXL

DX500 S3/DX600 S3 ETERNUS_DXM

DX400/DX400 S2 series ETERNUS_DX400

DX8000/DX8000 S2 series ETERNUS_DX8000

2.1.3 Enabling the device-mapper multipath

Enable the device-mapper multipath, using the following commands.

Check that device-mapper multipath can be started normally after executing the command.

# service multipathd start

When device-mapper multipath has already started, reload device-mapper multipath.

# service multipathd reload

2.1.4 Rebooting the Linux Server

Reboot the Linux server.

Example:

# shutdown -r now

Chapter 2 For Red Hat Enterprise Linux 7, Red Hat Enterprise Linux 6, or Oracle Linux

2.1 Setting Up the device-mapper multipath

FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection-

(Fibre Channel/FCoE/iSCSI/SAS) for Linux

P3AM-3912-21ENZ0

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 30 31

Sin comentarios

Red Hat DEVICE-MAPPER MULTIPATH 5.2 Manual de usuario Pagina 10