Red Hat SATELLITE 5.1.0 RELEASE NOTES Manual de instalación descargar pdf (Pagina 47)

Chapter 4. Installing and configuring z/VM 29

Figure 4-1 Integrated 3270 Console icon

A window entitled Integrated 3270 Console for <your CPC> will open. (On earlier HMC

levels, the window may be entitled Personal Communications).

5. Insert the z/VM Product Package Version 5 Release 4.0 DVD into the HMC DVD drive.

6. On a z9 HMC and earlier model, get into Single Object Operations mode (as mentioned,

for z10 HMCs and later, this step is not necessary). To get into this mode, perform the

following steps:

a. Double-click the Groups icon in the Views Area.

b. Double-click Defined CPCs in the Groups Work Area.

c. Select your CPC.

d. If necessary, go around the racetrack (the buttons with circular arrows on the bottom

right corner) to the CPC Recovery menu.

e. Double-click the Single Object Operations icon. Click yes to confirm. A new window

Primary Support Element Workplace should appear (on older HMC levels, it will be a

“window within a window”). A window about a certificate not being valid may appear; in

this case, press OK.

f. Double-click Groups near the top of this window.

g. Double-click Images in the Groups Work Area.

7. The LPAR that z/VM will be installed into should still be selected. On the right you should

still see the (CPC) Recovery menu. Double-click the Load from CD-ROM or Server icon

as shown in Figure 4-2 on page 30.

Hint: It is convenient to use the Alt-Tab key sequence to move between the HMC

window and the 3270 console.

Important: On z10 HMCs and later, it is no longer required to be in Single Object

Operations mode in order to install z/VM.

Important: If you are unable to get into Single Object Operations mode, it may be

because you do not have sufficient permission. Check with the system administrator.

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 267 268

Sin comentarios

Red Hat SATELLITE 5.1.0 RELEASE NOTES Manual de instalación Pagina 47