Red Hat SATELLITE 5.1.0 RELEASE NOTES Manual de instalación descargar pdf (Pagina 49)

Chapter 4. Installing and configuring z/VM 31

Figure 4-4 Selecting z/VM 5.4 RAMdisk system

b. From the Confirm the action window, click Yes. You should see the Load from

CD-ROM, DVD or Server Progress window. The green light on the DVD drive should

light up.

c. When you see the message Completed successfully., click OK to close. This should

normally take about two to four minutes.

At this point, you should now have an in-memory z/VM 5.4 system running.

4.1.2 Copying a vanilla z/VM system to DASD

This section describes the steps to copy z/VM to DASD.

1. You can now get out of Single object operations mode (if you are in it). To do so, log off the

primary SE window by closing that window.

2. Move to the Integrated 3270 Console window (you can use the Alt-Tab sequence). The

RAMdisk should IPL and you should see z/VM boot as shown in Figure 4-5 on page 32.

Important: Normally, the z/VM RAMdisk (IBMVMRAM) loads in about four minutes.

However, slow load times have been observed (15 to 18 minutes). When the green

light on the DVD drive is solid, the load time will be acceptable. When it is

intermittently dark more than it is green, long load times can result. This will also

balloon the estimated run time of 2 to 2.5 hours of the INSTDVD process, which may

consume 5 to 6 hours. PMR 58909,180 was opened to address this issue.

Note: The Esc key clears the window on the HMC.

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 267 268

Sin comentarios

Red Hat SATELLITE 5.1.0 RELEASE NOTES Manual de instalación Pagina 49